Lines Matching refs:no

165 You can add multiple values in a single line by adding an asterisk after the type (or after the key, if it has no type). The values should be separated by '',''. Note that you can also add multiple values just by writing multiple lines with the same key.
181 The field is generated from the fragment identifier if it is available. If the block has no fragment identifier, the page title is used as entry title. If you want to override the entry title of a data block, you can do so by adding the ''entry title'' field yourself.
373   * The default aggregate is to use no aggregation
412 The property ''%%ui%%'' specifies which user interface is shown and can have the values: ''%%none%%'', ''%%generic%%'', and ''%%table%%'' (only for tables). When the ''%%ui%%'' block is present, this property defaults to ''%%table%%'' for tables and ''%%generic%%'' otherwise. However, when no ''%%ui%%'' block is present, tables do have a ''%%table%%'' ui by default, since it is very subtle, but lists have no interactive ui.
421   * ''%%none%%'': no filtering.
463   sort*: no, yes, no
481   sort*: no,,no
484     sort: no
495 In general, the UI is quite intuitive, but combining it with aggregates might give unexpected results (unless you use a table, in which case no special handling is needed). The example below shows the column ''%%address%%'' twice: once the actual values and once the number of values. Because the UI creates filters per column, only one filter will be created for the ''%%address%%'' column. This filter filters both on addresses and number of addresses per person.